indian bullet gearbox issue

Has your Voskhod broke again? Suffering dodgy Italian electrics? Post your tales of woe here. Or ask odd questions about the rear wheel spacer on a Vincent Black Widow, should it take your fancy.
Bobber-job
Posts: 18
Joined: Tue Jun 03, 2014 9:14 pm

indian bullet gearbox issue

Unread post by Bobber-job » Fri Nov 24, 2017 12:27 pm

Hi I am rebuilding the gearbox on my 500 Indian Bullet. I have fitted the bearing and low gear to the mainshaft sleeve but as the gear is able to slide it touches the bearing. the bearing is tight against the shoulder. there is no spacer shown in any exploded drawings apart from 50's bullets. Is this normal? thanks in advance
Attachments
2017-11-23 18.07.46.jpg
2017-11-23 18.18.20.jpg

User avatar
Hooli
Posts: 10185
Joined: Thu Feb 19, 2009 11:52 pm
Location: Doncaster

Re: indian bullet gearbox issue

Unread post by Hooli » Mon Nov 27, 2017 7:37 pm

We used to have someone who knew all about Bullets, I hope they are still around.
Classics ain't built in Metric

Rick Parkington
Posts: 511
Joined: Mon Feb 23, 2009 1:21 am

Re: indian bullet gearbox issue

Unread post by Rick Parkington » Fri Dec 22, 2017 11:46 am

Hi folks, long time no speak.
I would say that if the bearing if splined to the shaft it will turn with the inner race of the bearing anyway, so there is no reason for the two not to touch. In this case there would usually be a slightly raised ring on the back of the gear - only a fag paper thick - a similar diameter to the bearing inner race, in order to make sure it is spaced away from the outer race of the bearing, which it certainly should not touch. If that isn't the case then something doesn't sound right.
Cheers Rick

Post Reply