Page 1 of 1

Factory cut out??

Posted: Sun Oct 29, 2017 8:36 pm
by pompeyboy1970
I recently purchased this and need some help with identifying it please? Can anyone help me?. Steve

Re: Factory cut out??

Posted: Sun Oct 29, 2017 10:01 pm
by DAM
Pictures are out of focus but it is a 32cc Cyclemate engine, basically a Cyclemaster engine that was fitted to a frame that Norman were contracted to design and make for them.

The give away is the foward facing carb inlet, the cyclemaster wheel engine had a rear facing carb. If I remember correctly it also had a modified disk vave to give it a miniscule power increase.( I have modified the disk valves on my Cyclemasters to give a bit more power to cope with my increasing weight).